Today, we will teach you how to distinguish the quality of Pipe Benders and choose high-quality pipe benders.

Here we mainly explain four points.

1. Measure the main parameters of the Hydraulic Pipe Bender: keep the pipe bender in an idling state, touch each module with your hand, and there should be no shaking in your hand, otherwise it will be regarded as a substandard product.

2. Install the equipment on the mold, crimp the sample joint, use a vernier caliper or micrometer to measure the crimp joint, the roundness and taper should be bent within 0.1mm, which is considered excellent.

Pipe Benders

3. Then check the uniform division of the eight petals of the mold base and the flatness of the mold. Good equipment will specifically control and adjust these two parameters, while some inferior equipment cannot control the above two parameters.

4. Finally, mold base hardness and mold hardness are also the key to normal use of equipment in the future. When the basic hardness of the mold is lower than Rockwell HRC60 and the mold hardness is lower than Rockwell HRC50, it will affect the quality of the hose withholding.

In order to produce high-quality Automatic Pipe Benders, in the production process, we also need to pay attention to the stability of the pipe bender. In short, it includes two aspects, one is its coincidence, the other is pressure. table. Only when these two aspects meet the requirements, the machine tool and the pipe bender die will not be damaged, and the quality requirements of the bent workpiece can be guaranteed. The pipe bending machine mold on the pipe bending machine is divided into upper and lower parts. The coincidence is the overlap of the upper mold and the lower mold of the pipe bender. In addition, it is divided into vertical overlap and horizontal overlap. When overlapping vertically, pay attention to the gap between the two, not too large or too small. Therefore, when adjusting the gap, you also need to pay attention to the adjustment of the pressure gauge.

Having said so much, have you learned? If you don’t remember and don’t know much, you can directly contact the supplier of the hydraulic elbow machine